Citroen 2cv tools     |     home
REAR WHEEL BEARING RING NUT EXTRACTOR
        CIT2CV064    
        previous  
TOOLS REQUIRED
44mm socket
55mm socket
hub locking bar
tube drift
drum puller
all sockets should be 3/4" drive.


REAR WHEEL BEARING RING NUT EXTRACTOR.
35MM 2CV TYPE.    PICTURES OF TOOL BELOW.
INSTRUCTIONS
REMOVING  AND INSTALLING THE RING NUT CAN NOW BE DONE IN SITU ON THE CAR INSTEAD OF ON THE BENCH IN A HEAVY VISE.
TAKE OFF THE 44mm HUB NUT AND SIMPLY FIT THE TOOL.
USE THE HUB LOCKING BAR TO JAMB THE DRUM SO THAT IT CANNOT ROTATE.
USE A 55mm SOCKET TO UNDO THE RING NUT.
NEXT, USE THE DRUM PULLER TO TAKE THE DRUM OFF.
RENEW  INNER OIL SEAL AND BEARING.
RE-FIT THE DRUM USING A TUBE DRIFT TO LOCATE THE BEARING ONTO THE STUB SHAFT.
LOCK THE DRUM AND INSTALL THE RING NUT.
SECURE DRUM WITH NEW 44mm NUT AND GREASE CAP.
NOTE...... THE THREADS ON THE STUB SHAFT MUST BE UNDAMAGED FOR THE TOOL SLEEVE TO FIT CORRECTLY.  THE PEENING PROCESS CAN DAMAGE THE THREADS IF NOT DONE PROPERLY.